2" x 72" SC Surface Conditioning Belt - A MED, Maroon (10)

These are premium surface conditioning non-woven web belts.
Use them for cleaning, finishing, blending, and light deburring applications.

These belts are perfect for final finishing in stainless steel finishing applications.
They can be used to generate a #3 through a #8 stainless steel finish.

The reinforced backing offers good flexibility.
Abrasive mineral is sharp cutting aluminum oxide.


How to Measure a Sanding Belt
Abrasive belts are always sized Width x Length (circumference).

To measure the Width of the belt:
1) Lay the belt on a flat surface and measure the width.

To measure the Length of the belt:
1) Make a small mark on the inside of the belt with a pen or marker
2) Make a corresponding mark on a large flat surface, benchtop or floor
3) Slowly roll the belt through a full rotation until the mark on the inside of the belt is once again touching the flat surface
4) Make a mark on the flat surface where it touches
5) Measuring between the 2 marks will give you the length of the belt