An accessory for the RCL-75 Searchlight.
Unlike other ACR searchlights, the RCL-75 Searchlight uses a Point Pad for remote control, as well as for second station installations (the same Point Pad is used for both). When purchased, the searchlight includes a primary controller Point Pad. This single purchase Point Pad is typically used for adding an additional control station.
The Point Pad comes with a bezel for surface mounting, but includes a plate for flush mountiing. Flush mounting requires 2 sets of ACR #9444 U-Clamps. (A total of 4 clamps.)
To add a second control station for the ACR RCL-75 Searchlight, you will need a splitter cable (#9442), an additional control station cable (#9426) for the second control pad, and possibly a control station extension cable (#9469) if the second station is very far away from the searchlight:
• The control cable that comes out of the searchlight terminates in a round connector which connects to an included 17 ft control station cable harness (#9426) that has a round connector at one end for the light, and a flat connector at the other end for the control pad.
• Disconnect the cables near the light and insert the #9442 splitter cable (which has 3 round connectors), reconnecting the original #9426 Point Pad cable to one leg of the splitter cable.
• Connect the round end of the second #9426 cable to the other leg of the splitter cable, and the flat end to the second Point Pad. If the 17 ft length of the #9426 cable is not long enough, you can connect a #9469 extension cable whidh has flat connectos at both ends - one connects to the flat end of the #9426 cable, and the other end to the Point Pad.
See Related Products, below for all these cables.