The Smart Bilge Pump Switch System constantly monitors for rising bilge water. There is zero current drain while monitoring, but immediately upon sensing bilge water the 30 amp switch turns on the bilge pump. The pump runs until it empties the bilge, then an additional 15 seconds to clear the bilge. If the pump cannot empty the bilge in 2 minutes, a signal is output to the panel mounted read light and optional bell (See AQA BA12 or RBA12). For large flat bilges this delay to alarm can be field adjusted to 3 minutes.
• Switches pump ON and OFF
• Pumps Additional 15 seconds to completely clear the bilge
• Warns of excessive pumping
• Handles pumps up to 30 Amps