Gen-Sep Water/Exhaust Separator, 1.62" Gensep 1.25" Drain, 15.63" H x 12.38" W x 5.03" D

In addition to a muffler, this device further reduces annoying genset exhaust noise while at dockside or moored overnight.
The Gen-Sep is installed downstream of a Vernalift muffler on generators, or small propulsion engines, to separate wet exhaust water and gas outflows. This results in noticeably reduced exhaust noise over the use of a muffler alone.
The irritating periodic surging and water splashing typical of wet exhausts is eliminated, and the exhaust gas sounds similar to a home dryer.

The Gen-Sep must be mounted so its bottom is at least 12" - 18" above the waterline; and its top must be no higher than 48" above the top of the Vernalift muffler.
Each Gen-Sep has two Inlet/Gas Out ports and a single Water Out port.

• Application: generators; choose size by matching hose size from the muffler
• Fuel type: gas or diesel
• Installation: above or below waterline, close to centerline
• Sound rating: best
• Acryllic white finish