A two package, polyamide cured, epoxy filler designed for use as a filler for pitted steel prior to maintenance coating. May also be used in fairing any irregularities which may occur in fabrication. Recommended as a protective layer for areas adjacent to impressed current anodes. In thickness of 1/4" or greater, can withstand up to 2 Amps of current after curing for 10 full days. You must mix an equal amount of Part A Base and Part B Converter.
• Requires an appropriate steel primer prior to application of Intergard 822
• Apply by brush or putty knife, then trowel flush with surface
• Theoretical coverage depends on film thickness
• Zero VOC
NOTE — You should purchase equal amounts of Base (Part A) and Converter (Part B); see Related Products, below.