S-2A Gasoline Fume Detector - Display Panel Only
Does Not Include Any Sensors Purchase This Panel When Sensor Wires Longer Than 20 ft Are Required
Sku# Make a selection
Item ID Make a selection
Mfg# Make a selection
Checking for Price and Availability
As low as $185.59
As low as $185.59
Purchase this S-2A display and alarm panel and the appropriate sensor or sensor components, when your installation requires a sensor cable longer than the 20 ft cable which comes in the standard kit.
Xintex® S-Series fume detectors offer common sense protection against the potential on-board hazards of propane and compressed natural gas (CNG).
With its high heat output and widespread availability, propane has become the fuel of choice for marine cooking and heating. Being flammable and also denser than air, should there be a leak in the system, propane gas can settle in enclosed areas of a boat, presenting an explosion hazard should there be a spark.
Unlike others, the Xintex fume sensor is splash-proof - allowing for mounting it right in the bilge, where propane vapors collect. It has a proprietary coating which is resistant to incidental water splashes, but allows vapors to pass.
While CNG (methane) is less dense than air and doesn't tend to settle, it can still explode if released in high enough concentrations and set off with a spark.
These Xintex fume detectors produce an audible and visible alarm when exposed to propane or CNG vapors. The "A" models also include circuitry to automatically close a solenoid valve - which shuts off the flow of propane or CNG, thus preventing additional leakage. The solenoid fails in the safe (off) mode, in case of electrical system failure.
As a dual-channel detector, the S-2A is suitable for monitoring 2 separate locations, or for placing two sensors in one very large compartment.
Although the MS-2 Sensor used in these systems can also detect gasoline vapors, the components of the S-series Detector Panels are geared toward propane/CNG.
For the specialized fume detection requirements of gasoline powered boats, please refer to the Xintex M-Series Gasoline Detectors; see Related Products, below.
• Self-testing circuitry for all operations
• Display dimensions: 4-3/4"W x 3-3/4"H x 7/8"D
• Display includes visual and auditory alarms
• Included sensor has a 20 foot sensor connector wire
• Factory set at 10 - 20% of lower explosive level to avoid nuisance alarms
• Sensor failure alarm
• Alarm horn mute function
• Made in USA
What's in the box...
The S-2A Display/Alarm Panel includes a display with alarm and rectangular bezel, with connections for up to 2 sensors and an electrical connection for an SV-1 automatic solenoid shut-off valve.
Click here for the Installation and Operation Manual for the S-2A.