MOB+ Multi Engine Wire Harness

The MOB+ Multi Engine Wiring harness is designed to combine the kill switch leads from multiple engines so they can be conveniently connected to the two leads on the MOB+ xHUB base unit.

Typically, this accessory is only needed for Yamaha and Honda powered multiple engine boats which are wired so every kill switch has its own set of wire leads - which must be combined using this harness to end up with just 2 leads going to the MOB+ xHUB base unit.

All other manufacturers combine the wires from each kill switch into just two leads - which can be connected directly to the xHUB wire harness.

This wire harness can be used to combine the leads from up to three engine kill switches.
If your boat has four engines, you will need to use two of these combiner harnesses to get the kill switch wire leads down to just two wires.