Self-Priming Sealed Macerator Pump

Self-Priming Sealed Macerator Pump

With Heavy-Duty Chopper Blades
By: Jabsco

Availability: Make a selection

Sku# Make a selection
Item ID Make a selection
Mfg# Make a selection
loading image
Checking Your Price
This sealed macerator pump provides the same performance as older macerators, but in a package that resists corrosion in harsh salt-water environments. The macerator is sealed by using a powder coated seamless motor yoke and front and rear motor endbells. Lip seals are located at the front and rear of the motor and a rubber grommmet seals the power wires.
• Inlet is a combination 1-1/2" hose barb/1-1/2" male NPT
• Outlet is a 1" hose barb
• Self-priming to 5 ft when wet, this pump will empty a typical 30 gallon holding tank in less than 3 minutes
• Fifteen minute continuous duty cycle, which means 180 gallons can be emptied in a single operation
• Run-dry protection mechanism shuts pump off
• New 4-blade stainless steel cutter reduces particles to 1/8" maximum
• Capable of passing waste, toilet tissue, facial tissue, cigarettes, cigars, chunks of soft fruit or vegetables less than 1" in size, fish scales or bait residue
• Permanent magnet motor; nitrile impeller
• Complies with USCG Regulation183.410 and ISO 8846 MARINE for Ignition Protection
• Service kit includes: fiber washers, short studs, gaskets, impeller, body, and seal
• NOTE: For replacement parts, see separate entry, or our website www.fisheriessupply.com
Reviewed by2customer 
Should be better quality for the price, October 12, 2015
The pump is about 2 years old and 3 of the 4 studs for the impeller housing corroded away.
By Kevin Dwyer from Seattle
Jabsco Macerator Pump, March 13, 2014
I have purchased three of the 12volt version and in each case in short order the thru bolts have sheared due to corrosion or have to much torque applied during manufacture. I have been sent the replacement stud to no avail because the stud breaks off in the plastic housing making it impossible to repair.
By Dan Rivera from Seattle
« Previous | PAGE1 of 1 | Next »

© Copyright Fisheries Supply Company 2013. All rights reserved.