This "Long Shaft" Hub threads onto the shaft of your long shaft grinder, allowing the end of the shaft to protrude through, so you can spin on a retaining nut over a traditional grinding disc, or spin on a TN threaded grinding disc.
This hub cannot be used on short shaft grinders, as it uses all the thread length.
See Related Products, below, for a hub suitable for use on short shaft grinders.
Use this Hub, and an appropriate Backing/Face Plate, with any Grinding Disc - either 3M's TN Quick-Connect spin-on discs, or traditional discs with a 7/8" center hole.
• Can be used with all 4" - 9" of backing plates
• See Related Products, below, for Grinding Disc Pad Backing/Face Plates
• If using traditional 7/8" hole discs, see Related Products, below, for Grinding Disc Retainer Nuts
This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm.
www.P65Warnings.ca.gov