The 7" (diagonal) Large Digital Remote Control Panel allows the operator to start/stop and monitor the watermaker from a remote location. It provides a digital readout of water quality, fault conditions, and allows programming of fresh water flush control, and more.
One-touch operation and intuitive customization procedures enable you to run and modify your system to meet your minute-by-minute needs.
• Staged starting of motors
• Timed start-up (Prime, Init, Run)
• TDS monitoring of product water
• Automatic diverting of water when salt level rises above 500 PPM
• Programmable Fresh Water Flush for automatic and weekly operation; or, convenient one-touch button for manual operation
• Overpressure protection (HP fault) Loss of Prime/Fouled Filter detection (LP fault)
• Remote system control up to 150 ft (50 ft cable included)
• Readout of product TDS
• Automatic tank level controls
• Programmable time/set points and display settings
• Higher heat tolerance allows installation in hot engine rooms
This panel comes complete with an instruction card and a 50 foot connection cable.
Install with confidence: Bridge Classified for marine use with Type Approval Certifications from: ABS, GL, Lloyd’s Register EMEA, Det Norske Veritas, and Russian Maritime Register of Shipping.
This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm.
www.P65Warnings.ca.gov