FES 576778 CORDLESS DRILL TPC 18/4 HPC 4,0 I-SET

The electronic kickback stop prevents your wrist from experiencing excess twisting if the drill suddenly becomes caught or jammed, therefore ensuring improved control when working. 1st gear: Demanding tightening of screws up to 3/8" (10 mm). 2nd gear: Quick screwdriving up to 5/16" x 11-13/32" (8 x 300 mm) in size. 3rd gear: Powerful drilling with auger bits of up to 3/4" (20 mm). 4th gear: Quick drilling with medium and small drill bits up to 1-3/8" (35 mm), for example Forstner drill bits. Fast, safe, direct! Switching in any direction – from any gear straight to any other, without intermediate stages. Clearly marked gear positions with solid engagement. 40% more torque compared to the previous model for greater rotational torque with 5/16" (8 mm) screws. Thanks to the smart FastFix interface, you can use all of the 18 V attachments from the Festool range and therefore benefit from the system advantages. No other cordless hammer drill offers this much variety!. For instantly changing between drilling, countersinking and driving: The CENTROTEC tool chuck, which has proven itself since 2001, is a chuck and bit holder in one. Even though it is half the size and weighs 80% less than a standard chuck. The brushless EC-TEC motor is wear-free and converts the energy from the battery into optimum power with virtually no losses. The electronic motor management also guarantees maximum service life: Microprocessors monitor and control the temperature, voltage and current consumption of the motor, electronics and battery. The latest generation of EC-TEC motors provides more torque and speed under load. Very quick angle adjustment simply by rotating the green ring. The attachment doesn't need to be removed from the machine. Even the eccentric adapter for driving close to edges is equipped with quick angle adjustment. Optimised torque adjustment to meet specific demands. A robust belt clip that can be attached on both sides and a bit holder for secure and magnetic bit storage at the side of the drill. Thanks to its smaller circumference, the optimised handle ensures improved ergonomics and easier handling. Systainer³ products are compatible with one another and can be connected to all previous Systainer generations, mobile dust extractors and many other system accessories, such as Sys-Cart, Sys-Roll, or the MW 1000 mobile workshop.