Powerboat transom-mount stern tunnels mount through the rear of the transom. Tunnel ends are flared to lessen turbulence.
2-Piece Composite Stern Tunnel (250mm) makes installation even easier, and can be used on any of the 250mm Tunnel Thrusters. Tunnel is ready bored, with extension harness for control box.
• Composite tunnels are 30% stronger than fiberglass stern tunnels
• Integrated support struts eliminate the need for a separate support for the motor
• Larger cut-out diameter (350 mm) makes it possible to install a completely assembled SE130 or SE170 stern thruster from the outside
• The tunnel comes in two halves that snap together, allowing easy access to the gearleg/propellers during assembly
Tunnel only (thruster not included).
This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm.
www.P65Warnings.ca.gov