No Snag Throttle Control, ATCU Lever Handle Only

Use the No Snag Throttle Control to retro-fit a standard Teleflex Side-Mount Engine Control to have a removable control handle to prevent lines and sheets from snagging on the throttle control lever.

The Spinlock No Snag Throttle Control is sold as separate components. This provides the option to purchase both the Faceplate and Control Lever, or to just purchase the Faceplate and use an existing sailboat winch handle as a control lever.

Operating Spinlock's "No Snags" throttle control under power is the same as with any standard throttle lever, except you can remove the lever at any time. As soon as the engine is shut down, the lever can be removed, leaving the bulkhead clear of obstruction, and eliminating the risk of a line getting caught.

• Works with Teleflex CH2100P, CH2600, and CH2700P side mount controls, which are sold separately
• Replaces original Telflex faceplate and handle
• Proven raceboat solution - allows the engine control to be located in the best position for the helmsman
• A sailboat sheet winch handle may be used in place of the Spinlock lever (shown)
• Morse conversion kits available by special order
• Lever and Faceplate components are sold separately