Vertical Cable Seal, Gray Plastic, 2 mm - 6 mm (0.08" - 0.24") Cable Cia

Scanstrut's range of Deck Seals provides waterproof thru-deck or thru-bulkhead cable routing without having to remove the connector at the end of the cable!

This is possible because each of the three included sealing bungs is pre-drilled for a common cable size, and then split - so it just slips onto the cable above the connector.
Furthermore, each kit also comes with a blank sealing bung for drilling your own holes for custom installations of multiple cables (freeze it in your freezer before drilling).

These deck seals are available in four sizes to accept cable connectors as large as 16mm (5/8"), 20mm (3/4"), 30mm (1-3/16"), or 40mm (1-9/16").

Each size deck seal comes in either high impact glass-filled nylon or 316 stainless steel.

These versatile deck seals are ideal for almost every thru-deck cable installation and are much easier to install than traditional models.

Features...
• Watertight installation - tapered bung forms watertight seal. All units are supplied with a closed-cell base seal which is 100% waterproof. All models have been IPX6 and IPX7 tested and approved.
• Easy and Reliable Installation - Captive nuts make for easy assembly and also allow reliable repeat installations. Each unit is supplied with both pre-drilled and blank inner seals to make your installation as easy as possible.
• No need to remove cable connectors - split-seal option does not require connector removal during installation.
• Multi-functional Dome Shape - Aesthetic dome-shaped profile provides a stronger, impact-resistant design (no sharp edges to hit your foot on!) and outer dome provides additional water shield.
• Your Choice of Materials - 30% Glass-filled Nylon – UV-stable, hard-wearing... or 316 stainless steel versions are available.
• Multi Deck Seal - Designed to fit multiple cables up to 15 mm diameter (9/16"). Supplied with undrilled seal and made from marine grade aluminum with hard finish to resist impact marks.

What's in the box...
• Flat Rubber Base Seal - placed centered on the hole you drilled in your deck for the cable
• Base Molding - goes over the base seal and has pre-drilled holes for fastening to your boat, and a second set of pre-drilled holes for the deck seal lid
• Rubber Bung Cable Seal - pre-drilled for several sizes of cables, plus one blank bung - which fits onto the base molding
• Nylon or Stainless Domed Cap - fits over the rubber bung and gets fastened to the base mold
• Instructions and all required fasteners are included